AudioCodes Mediant 800 - Filtering Tables in Web Interface by SRD

CHAPTER18 Core Entities
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
In normal operation scenarios in which the proxy
server is available, the device forwards the
REGISTER request to the proxy and if authenticated
by the proxy (i.e., device receives a success
response), the device adds the user to its registration
database. The routing to the proxy is according to the
SBC IP-to-IP Routing table where the destination is
the proxy’s IP Group. However, when the proxy is
unavailable (e.g., due to network connectivity loss),
the device can accept REGISTER requests from
new users if a matching alternative routing rule exists
in the SBC IP-to-IP Routing table where the
destination is the user’s User-type IP Group (i.e., call
survivability scenarios) and if the parameter is
enabled.
■ [0] Disable = The device rejects REGISTER
requests from new users that were not
authenticated by a proxy server.
■ [1] Enable = (Default) The device accepts
REGISTER requests from new users even if they
were not authenticated by a proxy server, and
registers the user in its registration database.
Note:
■ Regardless of the parameter, the device always
accepts registration refreshes from users that are
already registered in its database.
■ For a SIP Interface that is associated with the
SRD, if the corresponding parameter in the SIP
Interfaces table (SIPInterface_
EnableUnAuthenticatedRegistrations) is
configured to Disable or Enable, the parameter in
the SRD is ignored for calls belonging to the SIP
Interface.
■ The parameter is applicable only to the SBC
application.
Filtering Tables in Web Interface by SRD
When your configuration includes multiple SRDs, you can filter tables in the Web interface by
SRD. The filter is configured in the SRD Filter drop-down list, located on the Web interface's
toolbar, as shown below.
- 343 -