AudioCodes Mediant 800 - Direct Inward Dialing Parameters

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
You can also configure the feature per specific calls, using Tel
Profiles (TelProfile_DigitalCutThrough). For a detailed description of
the parameter and for configuring the feature in the Tel Profiles
table, see Configuring Tel Profiles.
Note:
■ If the feature is configured for a specific Tel Profile, the settings
of the global parameter is ignored for calls associated with the
Tel Profile.
■ The parameter is applicable only to digital interfaces (CAS).
Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 72-50:DID Parameters
Parameter Description
'DID Wink'
configure voip >
sip-definition
settings > did-
wink-enbl
[EnableDIDWink]
Global parameter enabling Direct Inward Dialing (DID) using
Wink-Start signaling, typically used for signaling between an E-
911 switch and the PSAP.
You can also configure the feature per specific calls, using Tel
Profiles (TelProfile_EnableDIDWink). For a detailed description
of the parameter and for configuring the feature in the Tel Profiles
table, see Configuring Tel Profiles.
Note:
■ The parameter is applicable to FXS and FXO interfaces.
■ If the feature is configured for a specific Tel Profile, the
settings of the global parameter is ignored for calls
associated with the Tel Profile.
'Time Between DID Winks'
configure voip >
sip-definition
settings > time-
between-did-winks
[TimeBetweenDIDWinks]
Defines the interval (in msec) for wink signaling:
■ Double-wink signaling [2]: interval between the first and
second wink
■ Wink and Polarity signaling [3]: interval between wink and
polarity change
The valid range is 100 to 2000. The default is 1000.
Note: See the EnableDIDWink parameter for configuring the
wink signaling type.
'Delay Before DID Wink'
configure voip >
sip-definition
settings > delay-
b4-did-wink
[DelayBeforeDIDWink]
Defines the time interval (in msec) between the detection of the
off-hook and the generation of the DID Wink.
The valid range is 0 to 1,000. The default is 0.
Note: The parameter is applicable only to FXS interfaces.
- 1330 -