AudioCodes Mediant 800 - Ini File Parameters

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
configure system > cli-
settings > default-
window-height
[DefaultTerminalWindowHeight]
The valid value range is -1 (default) and 0-65535:
■ A value of -1 means that the parameter is disabled and
the settings of the CLI command window-height is
used.
■ A value of 0 means that all the CLI output is displayed
in the window.
■ A value of 1 or greater displays that many output lines in
the window and if there is more output, the “—MORE—
" prompt is displayed. For example, if you configure the
parameter to 4, up to four output lines are displayed in
the window and if there is more output, the “—MORE—
" prompt is displayed (at which you can press the
spacebar to display the next four output lines).
Note: You can override this parameter for a specific CLI
session and configure a different number of output lines, by
using the window-height CLI command in the currently
active CLI session.
configure system >
mgmt-auth > obscure-
password-mode
[CliObscuredPassword]
Enables the device to enforce obscured (i.e., encrypted)
passwords whenever you create a new management user
or modify the password of an existing user, through CLI
(configure system > user) .
■ [0] = (Default) Disabled - passwords are configured in
plain text.
■ [1] = Enabled - passwords must be configured in
encrypted format. To obtain an encrypted (obscured)
password:
a. Enable the parameter.
b. Configure the user's password in the Web inter-
face's Local Users table (see Configuring Man-
agement User Accounts on page42).
c. Save the device's CLI Script file to your local PC
(see Saving and Loading CLI Script Files on
page944).
d. Open the file, and then copy the encrypted pass-
word to the CLI where you are configuring the user.
ini File Parameters
The parameters relating to ini-file management are described in the table below.
Table 72-4: ini File Parameters
Parameter Description
[INIPasswordsDisplayType] Defines how passwords are displayed in the ini file.
■ [0] = (default) Disable. Passwords are obscured
("encoded"). The passwords are displayed in the following
syntax: $1$<obscured password> (e.g., $1$S3p+fno=).
- 1160 -