AudioCodes Mediant 800 - 24 Trunk Groups; Configuring Trunk Groups

CHAPTER24 Trunk Groups
Mediant 800 Gateway & E-SBC | User's Manual
24 Trunk Groups
This section describes Trunk Group configuration.
Configuring Trunk Groups
The Trunk Group table lets you configure up to 24 Trunk Groups. A Trunk Group is a logical group of
physical trunks and channels. A Trunk Group can include multiple trunks and a range of channels.
To enable and activate the channels, you need to configure the Trunk Group and assign it telephone
numbers. Channels that are not configured in this table are disabled.
Once you have configured your Trunk Group, you can use it for call routing. To configure IP-to-Tel
routing rules, see Configuring IP-to-Tel Routing Rules. To configure Tel-to-IP routing rules, see
Configuring Tel-to-IP Routing Rules.
The following procedure describes how to configure Trunk Groups through the Web interface. You
can also configure it through ini file [TrunkGroup_x] or CLI (configure voip > gateway
trunk-group).
➢ To configure a Trunk Group:
1. Open the Trunk Group table (Setup menu > Signaling & Media tab > Gateway folder >
Trunks & Groups > Trunk Groups).
2. Configure a Trunk Group according to the parameters described in the table below.
3. Click Apply.
You can also register all your Trunk Groups. The registration method per Trunk Group is configured
by the 'Registration Mode' parameter in the Trunk Group Settings page (see Configuring Trunk
Group Settings).
■ To register Trunk Groups, click the Register button.
■ To unregister Trunk Groups, click the Unregister button.
- 594 -