AudioCodes Mediant 800 - ISDN Parameters

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
The value must be a positive value. The
default is -1.
'DTMF Min Detection Time'
[CASStateMachineDTMFMinOnDetectionTime]
Detects digit minimum on time (according
to DSP detection information event) in
msec units. The digit time length must be
longer than this value to receive a
detection. Any number may be used, but
the value must be less than
CasStateMachineDTMFMaxOnDetection
Time.
The value must be a positive value. The
default is -1.
'MAX Incoming Address Digits'
[CASStateMachineMaxNumOfIncomingAddress
Digits]
Defines the limitation for the maximum
address digits that need to be collected.
After reaching this number of digits, the
collection of address digits is stopped.
The value must be an integer. The default
is -1.
'MAX Incoming ANI Digits'
[CASStateMachineMaxNumOfIncomingANIDigi
ts]
Defines the limitation for the maximum
ANI digits that need to be collected. After
reaching this number of digits, the
collection of ANI digits is stopped.
The value must be an integer. The default
is -1.
'Collect ANI'
[CASStateMachineCollectANI]
In some cases, when the state machine
handles the ANI collection (not related to
MFCR2), you can enable the state
machine to collect ANI or discard ANI.
■ [0] No = Don't collect ANI.
■ [1] Yes = Collect ANI.
■ [-1] Default = Default value.
'Digit Signaling System'
[CASStateMachineDigitSignalingSystem]
Defines which Signaling System to use in
both directions (detection\generation).
■ [0] DTMF = DTMF signaling.
■ [1] MF = (Default) MF signaling.
■ [-1] Default = Default value.
ISDN Parameters
The ISDN parameters are described in the table below.
- 1342 -