AudioCodes Mediant 800 - Security Parameters; General Security Parameters

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ You must configure each device in the HA
system with different parameter values
(priorities).
'Redundant Preempt Priority'
configure network > high-
availability > redundant-
priority
[HARemotePriority]
Defines the priority of the redundant device used in
the HA Preempt mechanism.
The valid value is 1 (lowest priority) to 10 (highest
priority). The default is 5.
Note:
■ The parameter is applicable only if you configure
the 'Preempt Mode' parameter to Enable.
■ You must configure each device in the HA
system with different parameter values
(priorities).
HA Network Monitor Parameters
For more information, see Monitoring IP Entities and HA Switchover upon Ping Failure on
page892.
'HA Network Monitor'
configure network > high-
availability settings >
network-monitor-enabled
[HAPingEnabled]
Enables the HA Network Monitor feature, which
checks connectivity with network destinations,
using pings. When a user-defined number of
destinations fail the connectivity test (see 'Network
Monitor Threshold' parameter), an HA switchover
occurs.
■ [0] Disable (default)
■ [1] Enable
'Monitor Threshold'
configure network > high-
availability settings >
network-monitor-threshold
[HaNetworkMonitorThreshold]
Defines the minimum number of monitored rows (con-
figured in the HA Network Monitor table) whose des-
tinations are unreachable that are required to trigger
an HA switchover.
The valid value is 1 to 10. The default is 1.
Security Parameters
This subsection describes the device's security parameters.
General Security Parameters
The general security parameters are described in the table below.
Table 72-23:General Security Parameters
Parameter Description
Media Latching
'Inbound Media Latch Mode' Enables the Media Latching feature.
- 1200 -