CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
[MessagePolicyRejectRe
sponseType]
The default is 400 "Bad Request".
To configure Message Policies, see Configuring SIP Message
Policy Rules.
Channel Parameters
This section describes the device's channel parameters.
Voice Parameters
The voice parameters are described in the table below.
Table 72-33:Voice Parameters
Parameter Description
'Input Gain'
configure voip > media voice >
input-gain
[InputGain]
Global parameter defining the pulse-code
modulation (PCM) input (received) gain control
level (in decibels).
You can also configure the feature per specific
calls, using IP Profiles (IpProfile_InputGain) or
Tel Profiles (TelProfile_InputGain). For a detailed
description of the parameter and for configuring
the feature, see Configuring IP Profiles or
Configuring Tel Profiles.
Note: If the feature is configured for a specific
profile, the settings of the global parameter is
ignored for calls associated with the profile.
'Voice Volume'
configure voip > media voice >
voice-volume
[VoiceVolume]
Global parameter defining the voice gain control
(in decibels). This defines the level of the
transmitted signal (for the Gateway application, in
IP-to Tel calls).
You can also configure the feature per specific
calls, using IP Profiles (IpProfile_VoiceVolume)
or Tel Profiles (TelProfile_VoiceVolume). For a
detailed description of the parameter and for
configuring the feature, see Configuring IP
Profiles or Configuring Tel Profiles.
Note: If the feature is configured for a specific
profile, the settings of the global parameter is
ignored for calls associated with the profile.
configure voip > media voice
codecs > G726-voice-payload-
format
[VoicePayloadFormat]
Determines the bit ordering of the G.726 voice
payload format.
■ [0] = (Default) Little Endian
■ [1] = Big Endian
- 1266 -
To Next Page
Loading...
Need help?
General
