CHAPTER60 Viewing Network Status
Mediant 800 Gateway & E-SBC | User's Manual
60 Viewing Network Status
This section describes how to view network-related status.
Viewing Active IP Interfaces
You can view the device's active IP interfaces that are configured in the IP Interfaces table (see
Configuring IP Network Interfaces).
➢ To view active IP network interfaces:
■ Open the IP Interface Status page (Monitor menu > Monitor tab > Network Status folder >
IP Interface Status).
Viewing Ethernet Device Status
You can view the status of configured Ethernet Devices that have been successfully applied. To
configure Ethernet Devices, see Configuring Underlying Ethernet Devices.
➢ To view Ethernet Device status:
■ Open the Ethernet Device Status page (Monitor menu > Monitor tab > Network Status folder
> Ethernet Device Status).
Viewing Ethernet Port Information
You can view status information of the device's Ethernet ports. To configure Ethernet ports, see
Configuring Underlying Ethernet Devices.
If the device is operating in High-Availability mode, you can also view Ethernet port
information of the redundant device, by opening the Redundant Ethernet Port
Information page (Monitor menu > Monitor tab > Network Status folder > Redundant
Ethernet Port Information).
➢ To view Ethernet port information:
■ Open the Ethernet Port Information table, by doing one of the following:
● Navigation tree: Monitor menu > Monitor tab > Network Status folder > Ethernet Port
Information.
● Monitor home page: Click an Ethernet port on the graphical display of the device (see
Viewing Device Status on Monitor Page).
- 1025 -
To Next Page
Loading...
