EasyManua.ls Logo

AudioCodes Mediant 800 - Automatic Update Parameters

AudioCodes Mediant 800
1482 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
For the parameter to take effect, a device reset is
required.
'CAS File'
[CASFileName_x]
Defines the CAS file name (e.g., 'E_M_WinkTable.dat'),
which defines the CAS protocol (where x denotes the CAS
file ID 0 to 7). It is possible to define up to eight different CAS
files by repeating the parameter. Each CAS file can be
associated with one or more of the device's trunks, using the
parameter CASTableIndex or it can be associated per B-
channel using the parameter CASChannelIndex.
For the ini file, the name must be enclosed by single
apostrophes, for example, 'cas_us.dat'.
Note: For the parameter to take effect, a device reset is
required.
'Dial Plan'
[CasTrunkDialPlanName_x]
Defines the Dial Plan name (up to 11-character strings) per
trunk.
For the ini file, the name must be enclosed by single
apostrophes, for example, 'dial_plan_2.dat'.
Note: The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.
'Dial Plan File'
[DialPlanFileName]
Defines the name of the Dial Plan file.
For the ini file, the name must be enclosed by single
apostrophes, for example, 'dial_plan.dat'.
Note: This parameter is used only for backward
compatibility. For loading (importing) Dial Plan files, use the
Dial Plan table instead (see Importing Dial Plans on
page518).
[UserInfoFileName] Defines the name of the file containing the User Information
data.
For the ini file, the name must be enclosed by single
apostrophes, for example, 'userinfo_us.dat'.
Note: The parameter is only used for backward compatibility.
Automatic Update Parameters
The automatic update of software and configuration files parameters are described in the table
below.
Auxiliary file upload through TFTP is not supported by HA mode.
Table 72-8: Automatic Update of Software and Configuration Files Parameters
Parameter Description
General Automatic Update Parameters
CLI path: configure system > automatic-update
- 1169 -

Table of Contents

Other manuals for AudioCodes Mediant 800

Related product manuals