AudioCodes Mediant 800 - Resource Allocation Indication Parameters

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
'Debug Recording Destination
Port'
configure troubleshoot
> logging settings >
dbg-rec-dest-port
[DebugRecordingDestPort]
Defines the UDP port of the server for capturing debug
recording. The default is 925.
'Enable Core Dump'
[EnableCoreDump]
Enables the automatic generation of a Core Dump file upon
a device crash.
■ [0] Disable (default)
■ [1] Enable
Note: For the parameter to take effect, a device reset is
required.
'Core Dump Destination IP'
[CoreDumpDestIP]
Defines the IP address of the remote server where you
want the device to send the Core Dump file.
By default, no IP address is defined.
'Call Flow Report Mode'
call-flow-report
[CallFlowReportMode]
Enables the device to send SIP call messages to OVOC
so that OVOC can display SIP call dialog sessions as SIP
call flow diagrams.
■ [0] Disable (default)
■ [1] Enable
For more information, see Enabling SIP Call Flow
Diagrams in OVOC on page1123.
Resource Allocation Indication Parameters
The Resource Allocation Indication (RAI) parameters are described in the table below.
Table 72-20:RAI Parameters
Parameter Description
[EnableRAI] Enables Resource Available Indication (RAI) alarm generation if the
device's busy endpoints exceed a user-defined threshold, configured
by the RAIHighThreshold parameter. When enabled and the threshold
is crossed, the device sends the SNMP trap,
acBoardCallResourcesAlarm.
■ [0] = (Default) Disable
■ [1] = Enable
Note: For the parameter to take effect, a device reset is required.
[RAIHighThreshold] Defines the high threshold percentage of total calls that are active
(busy endpoints). When the percentage of the device's busy endpoints
exceeds this high threshold, the device sends the SNMP
acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.
The range is 0 to 100. The default is 90.
- 1196 -