AudioCodes Mediant 800 - HTTP-Based Services

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
LDAP PRIVATE Number Attribute
Name
configure voip > sip-
definition settings > ldap-
private-nm-attr
[MSLDAPPrivateNumAttributeName]
Defines the name of the attribute that represents the
user's private number in the AD. If this value equals
the value of the MSLDAPPrimaryKey or
MSLDAPSecondaryKey parameter, then the device
queries the AD for the destination number in this
private attribute name; otherwise, the parameter is
not used as a search key.
The default is "msRTCSIP-PrivateLine".
'LDAP DISPLAY Name Attribute
Name'
configure voip > sip-
definition settings > ldap-
display-nm-attr
[MSLDAPDisplayNameAttributeName]
Defines the attribute name that represents the
Calling Name in the AD for LDAP queries based on
calling number.
The valid value is a string of up to 49 characters.
The default is "displayName".
LDAP Primary Key
configure voip > sip-
definition settings > ldap-
primary-key
[MSLDAPPrimaryKey]
Defines the name of the attribute used as a query
search key for the destination number in the AD.
This is used instead of the "PBX" attribute name
(configured by the
MSLDAPPBXNumAttributeName parameter).
The default is not configured.
LDAP Secondary Key
configure voip > sip-
definition settings > ldap-
secondary-key
[MSLDAPSecondaryKey]
Defines the name of the attribute used as the
second query search key for the destination number
in the AD, if the primary search key or PBX search
is not found.
'LDAP Cache Service'
configure system > ldap
settings > ldap-cache-enable
[LDAPCacheEnable]
Enables the LDAP cache service.
■ [0] Disable (default)
■ [1] Enable
Note:
■ For the parameter to take effect, a device reset
is required.
■ For more information on LDAP caching, see
Configuring the Device's LDAP Cache.
HTTP-based Services
The HTTP-based service parameters are described in the table below.
Table 72-73:HTTP-based Service Parameters
Parameter Description
'GW Routing Server'
configure voip > gw routing general-
setting > gw-routing-server
[GWRoutingServer]
Enables routing by a Routing
server.
■ [0] Disable (default)
■ [1] Enable
- 1436 -