CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
[MWIExpirationTime]
'MWI Subscribe Retry Time'
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-
subs-rtry-time
[SubscribeRetryTime]
Defines the subscription retry time (in seconds) after
last subscription failure.
The default is 120 seconds. The range is 10 to
2,000,000.
'Subscription Mode'
configure voip > sip-
definition proxy-and-
registration >
subscription-mode
[SubscriptionMode]
Determines the method the device uses to subscribe to
an MWI server.
■ [0] Per Endpoint = (Default) Each endpoint
subscribes separately - typically used for FXS
interfaces.
■ [1] Per Gateway = Single subscription for the entire
device - typically used for FXO interfaces.
configure voip >
interface fxs-fxo > etsi-
vmwi-type-one-standard
[ETSIVMWITypeOneStandard]
Determines the ETSI Visual Message Waiting
Indication (VMWI) Type 1 sub-standard.
■ [0] = (Default) ETSI VMWI between rings
■ [1] = ETSI VMWI before ring DT_AS
■ [2] = ETSI VMWI before ring RP_AS
■ [3] = ETSI VMWI before ring LR_DT_AS
■ [4] = ETSI VMWI not ring related DT_AS
■ [5] = ETSI VMWI not ring related RP_AS
■ [6] = ETSI VMWI not ring related LR_DT_AS
Note: For the parameter to take effect, a device reset is
required.
configure voip >
interface fxs-fxo >
bellcore-vmwi-type-one-
standard
[BellcoreVMWITypeOneStandard]
Determines the Bellcore VMWI sub-standard.
■ [0] = (Default) Between rings.
■ [1] = Not ring related.
Note: For the parameter to take effect, a device reset is
required.
Call Hold Parameters
The call hold parameters are described in the table below.
Table 72-45:Call Hold Parameters
Parameter Description
'Enable Hold'
configure voip >
gateway dtmf-supp-
service supp-
service-settings >
hold
[EnableHold]
Global parameter that enables the following:
■ Analog interfaces: Call Hold feature
■ Digital interfaces: Interworking of the Hold/Retrieve
supplementary service from ISDN to SIP.
- 1314 -
To Next Page
Loading...
