AudioCodes Mediant 800 - Packetsmart Parameters

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of “enabled” endpoints
(trunks are physically connected and synchronized without alarms and
endpoints are defined in the Trunk Group table).
[RAILowThreshold] Defines the low threshold percentage of total calls that are active (busy
endpoints).
When the percentage of the device's busy endpoints falls below this
low threshold, the device sends an SNMP
acBoardCallResourcesAlarm alarm trap with a 'cleared' alarm status.
The range is 0 to 100%. The default is 90%.
[RAILoopTime] Defines the time interval (in seconds) that the device periodically
checks call resource availability.
The valid range is 1 to 200. The default is 10.
PacketSmart Parameters
The PacketSmart parameters are described in the table below. For more information on
PacketSmart, see Configuring PacketSmart for Network Monitoring.
Table 72-21:PacketSmart Parameters
Parameter Description
'PacketSmart Agent Mode'
configure system >
packetsmart enable
[PacketSmartAgentMode]
Enables the embedded PacketSmart agent.
■ [0] Disable (Default)
■ [1] Enable
Note: For the parameter to take effect, a device reset is
required.
'PacketSmart Server IP Address'
configure system >
packetsmart server
address
[PacketSmartIpAddress]
Defines the IP address of the PacketSmart server with
which the PacketSmart agent communicates.
The default is 0.0.0.0.
'PacketSmart Server Port'
configure system >
packetsmart server port
[PacketSmartIpAddressPort]
Defines the TCP port of the PacketSmart server to which
the PacketSmart agent connects.
The default is 80.
'Monitoring Interface'
configure system >
packetsmart monitor
voip interface-if
[PacketSmartMonitorInterface]
Assigns an IP network interface (configured in the IP
Interfaces table) that handles the voice traffic.
Note: For the parameter to take effect, a device reset is
required.
'Network Interface' Assigns an IP network interface (configured in the IP
Interfaces table) for communicating with the PacketSmart
server. This is typically the OAMP interface.
- 1197 -