EasyManua.ls Logo

AudioCodes Mediant 800 - TLS Parameters

AudioCodes Mediant 800
1482 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
configure voip > sip-definition
settings > srtp-state-behavior-mode
[ResetSRTPStateUponRekey]
Global parameter that enables
synchronization of the SRTP state
between the device and a server when a
new SRTP key is generated upon a SIP
session expire. You can also configure
this feature per specific calls, using IP
Profiles (IpProfile_
ResetSRTPStateUponRekey). For a
detailed description of the parameter and
for configuring this feature in the IP
Profiles table, see Configuring IP Profiles.
Note: If this feature is configured for a
specific IP Profile, the settings of this
global parameter is ignored for calls
associated with the IP Profile.
TLS Parameters
The Transport Layer Security (TLS) parameters are described in the table below.
Table 72-26:TLS Parameters
Parameter Description
'TLS Client Re-Handshake Interval'
configure network >
security-settings > tls-re-
hndshk-int
[TLSReHandshakeInterval]
Defines the time interval (in minutes) between TLS
Re-Handshakes initiated by the device.
The interval range is 0 to 1,500 minutes. The default
is 0 (i.e., no TLS Re-Handshake).
'TLS Mutual Authentication'
configure network >
security-settings >
SIPSREQUIRECLIENTCERTIFICATE
[SIPSRequireClientCertificate]
Defines the device's mode of operation regarding
mutual authentication and certificate verification for
TLS connections.
[0] Disable = (Default)
Device acts as a client: Verification of the
server’s certificate depends on the
VerifyServerCertificate parameter.
Device acts as a server: The device does
not request the client certificate.
[1] Enable =
Device acts as a client: Verification of the
server certificate is required to establish the
TLS connection.
Device acts as a server: The device
requires the receipt and verification of the
client certificate to establish the TLS
connection.
Note:
This feature can be configured per SIP Interface
(see Configuring SIP Interfaces).
- 1208 -

Table of Contents

Other manuals for AudioCodes Mediant 800

Related product manuals