CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ For RADIUS login authentication to function, you must
also configure the EnableRADIUS parameter to 1
(Enable).
■ RADIUS authentication requires HTTP basic
authentication, where the username and password are
transmitted in clear text over the network. Therefore, it's
recommended to set the HTTPSOnly parameter to 1 to
force the use of HTTPS, since the transport is encrypted.
'Password Local Cache
Mode'
configure system >
radius settings >
local-cache-mode
[RadiusLocalCacheMode]
Defines the device's mode of operation regarding the timer
(configured by the parameter RadiusLocalCacheTimeout)
that determines the validity of the username and password
(verified by the RADIUS server).
■ [0] Absolute Expiry Timer = When you access a Web
page, the timeout doesn't reset, instead it continues
decreasing.
■ [1] Reset Timer Upon Access = (Default) Upon each
access to a Web page, the timeout always resets (reverts
to the initial value configured by
RadiusLocalCacheTimeout).
'Password Local Cache
Timeout'
configure system >
radius settings >
local-cache-timeout
[RadiusLocalCacheTimeout]
Defines the time (in seconds) the locally stored username and
password (verified by the RADIUS server) are valid. When
this time expires, the username and password become invalid
and a must be re-verified with the RADIUS server.
The valid range is 1 to 0xFFFFFF. The default is 300 (5
minutes).
■ [-1] = Never expires.
■ [0] = Each request requires RADIUS authentication.
'RADIUS VSA Access Level
Attribute'
configure system >
radius settings >
vsa-access-level
[RadiusVSAAccessAttribute]
Defines the code that indicates the access level attribute in
the Vendor Specific Attributes (VSA) section of the received
RADIUS packet.
The valid range is 0 to 255. The default is 35.
LDAP Parameters
The Lightweight Directory Access Protocol (LDAP) parameters are described in the table below.
Table 72-72:LDAP Parameters
Parameter Description
'LDAP Service'
configure system > ldap
settings > ldap-service
[LDAPServiceEnable]
Enables the LDAP feature.
■ [0] Disable (default)
■ [1] Enable
Note: For the parameter to take effect, a device
reset is required.
- 1434 -
To Next Page
Loading...
