AudioCodes Mediant 800 - SIP Test Call Parameters

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
configure voip > sip-
definition advanced-
settings > delay-
after-reset
[GWAppDelayTime]
Note: This feature helps overcome connection problems
caused by some LAN routers or IP configuration
parameters' modifications by a DHCP server.
[DualPowerSupplySupported] Enables the device to send an SNMP alarm
(acPowerSupplyAlarm) for one or both Power Supply
modules if a module is removed from the chassis or not
operating correctly (failure).
■ [1] = (Default) Disable. The alarm is applicable only to
the main Power Supply module (#1). The device sends
the alarm if this module is removed from the chassis or
fails. The alarm is not sent for the secondary Power
Supply module (#2) even if it is removed or fails.
■ [2] = Enable. The alarm is applicable to both Power
Supply modules. If any of the modules are removed or
fail, the device sends the alarm, indicating the affected
module.
Note:
■ For the parameter to take effect, a device reset is
required.
■ The parameter is applicable only to the Mediant 800
Gateway & E-SBC H/W Rev C.
■ If configured to [2], make sure that the device is installed
with two Power Supply modules. If only one module is
installed, the device will send an alarm indicating a
removed module.
■ If you want to use only one Power Supply module for the
device, make sure that the parameter is configured to
[1]; otherwise, an alarm will be raised indicating a
removed module.
[EnableAutoRAITransmitBER] Enables the device to send a remote alarm indication (RAI)
when the bit error rate (BER) is greater than 0.001.
■ [0] = Disable (default)
■ [1] = Enable
'Ignore BRI LOS Alarm'
ignore-bri-los-alarm
[IgnoreBRILOSAlarm]
Enables the device to ignore LOS alarms received from the
BRI user-side trunk and attempts to make a call (relevant for
IP-to-Tel calls).
■ [0] Disable
■ [1] Enable (default)
Note: The parameter is applicable only to BRI interfaces.
SIP Test Call Parameters
The SIP Signaling Test Call parameters are described in the table below.
- 1187 -