AudioCodes Mediant 800 - Telephony Tone Parameters; Tone Parameters

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
2. A places B on hold and calls C; C answers the call.
3. A performs a call transfer (the transfer is done internally by
the PBX); B and C are connected to one another.
In the above example, the PBX updates B that it is now talking
with C. The PBX updates this by sending a QSIG Facility
message with CallTranferComplete invoke APDU. The device
interworks this message to a SIP UPDATE message containing
a P-Asserted-Identity header with the number and name derived
from the QSIG CallTranferComplete RedirectionNumber and
RedirectionName.
Note:
■ For IP-to-Tel calls, the RedirectionNumber and
RedirectionName in the CallTRansferComplete invoke is
derived from the P-Asserted-Identity and Privacy headers in
the received SIP INFO message.
■ To include the P-Asserted-Identity header in outgoing SIP
UPDATE messages, set the AssertedIDMode parameter to
Add P-Asserted-Identity.
is-cas-sndhook-flsh
[CASSendHookFlash]
Enables sending Wink signal toward CAS trunks.
■ [0] = Disable (default)
■ [1] = Enable
If the device receives a mid-call SIP INFO message with
flashhook event body (as shown below) and the parameter is set
to 1, the device generates a wink signal toward the CAS trunk.
The CAS wink signal is done by changing the A bit from 1 to 0,
and then back to 1 for 450 msec.
INFO sip:4505656002@192.168.13.40:5060
SIP/2.0
Via: SIP/2.0/UDP 192.168.13.2:5060
From: <sip:06@192.168.13.2:5060>
To:
<sip:4505656002@192.168.13.40:5060>;tag=13287
8796-1040067870294
Call-ID: 0010-0016-D69A7DA8-1@192.168.13.2
CSeq:2 INFO
Content-Type: application/broadsoft
Content-Length: 17
event flashhook
Note: The parameter is applicable only to T1 CAS protocols.
Tone Parameters
This subsection describes the device's tone parameters.
Telephony Tone Parameters
The telephony tone parameters are described in the table below.
- 1360 -