AudioCodes Mediant 800 - Page 1401

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Table 72-57:Tone Parameters
Parameter Description
'Maximum simultaneous streaming
calls'
max-streaming-calls
[MaxStreamingCalls]
Defines the maximum number of concurrent call parties
that have been placed on hold to which the device can
play Music on Hold (MoH) that originates from an
external media player.
The maximum is 20. The default is 0.
For more information, see Configuring MoH from
External Audio Source on page669.
Note:
■ The parameter is applicable only to FXS interfaces.
■ Each FXS port supports up to 20 concurrent MoH
sessions.
■ For the parameter to take effect, a device reset is
required.
'SIP Hold Behavior'
configure voip > sip-
definition settings >
sip-hold-behavior
[SIPHoldBehavior]
Enables the device to handle incoming re-INVITE
messages with the "a=sendonly" attribute in the SDP,
in the same way as if an "a=inactive" is received in the
SDP. When enabled, the device plays a held tone to the
Tel phone and responds with a SIP 200 OK containing
the "a=recvonly" attribute in the SDP.
■ [0] Disable (default)
■ [1] Enable
Note: The parameter is applicable only to analog
interfaces.
'Dial Tone Duration'
configure voip > gateway
dtmf-supp-service dtmf-
and-dialing > dt-duration
[TimeForDialTone]
Defines the duration (in seconds) that the dial tone is
played.
Digital interfaces: The tone is played to an ISDN
terminal. The parameter is applicable for overlap dialing
when ISDNInCallsBehavior is set to 65536. The dial
tone is played if the ISDN Setup message doesn't
include the called number. The valid range is 0 to 60.
The default is 5.
Analog interfaces: FXS interfaces play the dial tone
after the phone is picked up (off-hook). FXO interfaces
play the dial tone after the port is seized in response to
ringing (from PBX/PSTN). The valid range is 0 to 60.
The default time is 16.
Note:
■ Analog interfaces: During play of dial tone, the
device waits for DTMF digits.
■ Analog interfaces: The parameter is not applicable
when Automatic Dialing is enabled.
- 1361 -