AudioCodes Mediant 800 - 4 Configuring Voip LAN Interface for OAMP; Changing OAMP Address through Web Interface

CHAPTER4 Configuring VoIP LAN Interface for OAMP
Mediant 800 Gateway & E-SBC | User's Manual
4 Configuring VoIP LAN Interface for OAMP
You can change the device's default OAMP IP address, using any of the following methods:
■ Embedded HTTP/S-based Web server (see Web Interface)
■ Embedded CLI (see CLI)
■ ini file (see Changing OAMP Address through ini File on page15
If you are implementing the High Availability feature, see also HA Overview for initial
setup.
Changing OAMP Address through Web Interface
You can change the device's default OAMP networking address through the Web- based
management tool (Web interface). The default IP address is used to initially access the device.
➢ To change the default OAMP network address through Web interface:
1. Connect Port 1 (left-most LAN port) located on the front panel directly to the network interface
of your computer, using a straight-through Ethernet cable.
2. Change the IP settings of your computer to correspond with the default OAMP IP address and
subnet mask of the device.
3. Access the Web interface:
a. On your computer, start a Web browser and in the URL address field, enter the default IP
address of the device; the Web interface's Web Login screen appears:
- 12 -