AudioCodes Mediant 800 - 65 Debugging Web Services

CHAPTER65 Debugging Web Services
Mediant 800 Gateway & E-SBC | User's Manual
65 Debugging Web Services
If you have configured remote Web services (see Remote Web Services ), you can enable
debugging of the remote HTTP clients. You can configure the debug level from 1 to 3, where 3 is the
most detailed. The debug messages are sent to the Syslog server.
➢ To configure debugging of Web services:
1. Open the Web Service Settings page (Setup menu > IP Network tab > Web Services folder >
Web Service Settings).
2. In the 'Debug Level' field (RestDebugMode), enter the debug level (or disable debugging by
configuring it to 0):
3. Click Apply.
- 1122 -