AudioCodes Mediant 800 User Manual

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
[DigitPatternForwardOnNoAnswerExt]
'Forward on Do Not Disturb Digit
Pattern (External)'
configure voip > gateway
voice-mail-setting > fwd-
dnd-dig-ptrn-ext
[DigitPatternForwardOnDNDExt]
Defines the digit pattern used by the PBX to
indicate 'call forward on do not disturb' when the
original call is received from an external line (not an
internal extension).
The valid range is a 120-character string.
'Forward on No Reason Digit Pattern
(External)'
configure voip > gateway
voice-mail-setting > fwd-no-
rsn-dig-ptrn-ext
[DigitPatternForwardNoReasonExt]
Defines the digit pattern used by the PBX to
indicate 'call forward with no reason' when the
original call is received from an external line (not an
internal extension).
The valid range is a 120-character string.
'Internal Call Digit Pattern'
configure voip > gateway
voice-mail-setting > int-
call-dig-ptrn
[DigitPatternInternalCall]
Defines the digit pattern used by the PBX to
indicate an internal call.
The valid range is a 120-character string.
'External Call Digit Pattern'
configure voip > gateway
voice-mail-setting > ext-
call-dig-ptrn
[DigitPatternExternalCall]
Defines the digit pattern used by the PBX to
indicate an external call.
The valid range is a 120-character string.
'Disconnect Call Digit Pattern'
configure voip > gateway
voice-mail-setting > disc-
call-dig-ptrn
[TelDisconnectCode]
Defines a digit pattern that when received from the
Tel side, indicates the device to disconnect the call.
The valid range is a 25-character string.
'Digit To Ignore Digit Pattern'
configure voip > gateway
voice-mail-setting > dig-to-
ignore-dig-pattern
[DigitPatternDigitToIgnore]
Defines a digit pattern that if received as Src (S) or
Redirect (R) numbers is ignored and not added to
that number.
The valid range is a 25-character string.
Supplementary Services Parameters
This subsection describes the device's supplementary telephony services parameters.
Caller ID Parameters
The caller ID parameters are described in the table below.
- 1304 -

AudioCodes Mediant 800 Specifications

General

Protocols	SIP, H.323
Digital Interfaces	1/2 E1/T1 PRI
Management	Web, CLI, SNMP
Mounting	19-inch rack
Codecs	G.711, G.729, G.722, G.723.1
Power Supply	100-240V AC
Operating Temperature	0 to 40°C
Storage Temperature	-25 to 70°C
Humidity	10% to 90% non-condensing