CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
[SerialStop] Defines the serial communication stop bit.
■ [1] = (Default) 1-bit (default)
■ [2] = 2-bit
Note: For the parameter to take effect, a device reset is required.
[SerialFlowControl] Defines the serial communication flow control.
■ [0] = (Default) None
■ [1] = Hardware
Note: For the parameter to take effect, a device reset is required.
Auxiliary and Configuration File Name Parameters
The table below lists the parameters associated with the Auxiliary files. For more information on
Auxiliary files, see Loading Auxiliary Files.
Table 72-7: Auxiliary and Configuration File Parameters
Parameter Description
General Parameters
[SetDefaultOnIniFileProcess] Determines if all the device's parameters are set to their
defaults before processing the updated ini file.
■ [0] = Disable - parameters not included in the downloaded
ini file are not returned to default settings (i.e., retain their
current settings).
■ [1] = Enable (default).
Note: The parameter is applicable only for automatic HTTP
update or Web ini file upload (not applicable if the ini file is
loaded using BootP).
[SaveConfiguration] Determines if the device's configuration (parameters and
files) is saved to flash (non-volatile memory).
■ [0] = Configuration isn't saved to flash memory.
■ [1] = (Default) Configuration is saved to flash memory.
Auxiliary Filename Parameters
'Call Progress Tones File'
[CallProgressTonesFilename]
Defines the name of the file containing the Call Progress
Tones definitions.
For the ini file, the name must be enclosed by single
apostrophes, for example, 'cpt_us.dat'.
For more information on how to create and load this file, refer
to DConvert Utility User's Guide.
Note: For the parameter to take effect, a device reset is
required.
'Prerecorded Tones File'
[PrerecordedTonesFileName]
Defines the name of the file containing the Prerecorded
Tones.
Note:
- 1168 -
To Next Page
Loading...
Need help?
General
