AudioCodes Mediant 800 - SNMP Parameters

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ [1] = Enable. All passwords are hidden and replaced by an
asterisk (*).
SNMP Parameters
The SNMP parameters are described in the table below.
Table 72-5: SNMP Parameters
Parameter Description
'Disable SNMP'
configure system > snmp settings
> disable
[DisableSNMP]
Enables and disables SNMP.
■ [0] No = (Default) SNMP is enabled.
■ [1] Yes = SNMP is disabled.
Note: For the parameter to take effect, a
device reset is required.
configure system > snmp settings
> port
[SNMPPort]
Defines the device's local (LAN) UDP port
used for SNMP Get/Set commands.
The range is 100 to 3999. The default port is
161.
Note: For the parameter to take effect, a
device reset is required.
[ChassisPhysicalAlias] Defines the 'alias' name object for the
physical entity as specified by a network
manager, and provides a non-volatile
'handle' for the physical entity.
The valid range is a string of up to 255
characters.
[ChassisPhysicalAssetID] Defines the user-assigned asset tracking
identifier object for the device's chassis as
specified by OVOC, and provides non-
volatile storage of this information.
The valid range is a string of up to 255
characters.
[ifAlias] Defines the textual name of the interface.
The value is equal to the ifAlias SNMP MIB
object.
The valid range is a string of up to 64
characters.
- 1161 -