AudioCodes Mediant 800 - HTTP Proxy Parameters

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
For more information, see
Centralized Third-Party Routing
Server.
Note: The parameter is
applicable only to the Gateway
application.
'Quality Status'
configure system > http-services >
routing-qos-status
[RoutingServerQualityStatus]
Enables QoS-based routing by
the routing server. The device
collects QoS metrics (media and
signaling) and sends them to the
routing server.
■ [0] Disable (default)
■ [1] Enable
For more information, see
Configuring QoS-Based Routing
by Routing Server.
'Quality Status Rate'
configure system > http-services >
routing-qos-status-rate
[RoutingServerQualityStatusRate]
Defines the rate (in sec) at which
the device sends QoS reports to
the routing server.
The valid range is 15-3600. The
default is 60.
For more information, see
Configuring QoS-Based Routing
by Routing Server.
'Topology Status'
configure system > http-services >
routing-server-group-status
[RoutingServerGroupStatus]
Enables the reporting of the
device's topology status (using
the REST TopologyStatus API
command) to HTTP remote
hosts.
■ [0] Disable (default)
■ [1] Enable
For more information, see
Configuring HTTP Services.
HTTP Proxy Parameters
The HTTP Proxy service parameters are described in the table below.
Table 72-74:HTTP Proxy Service Parameters
Parameter Description
'HTTP Proxy Application'
configure network > http-proxy >
http-proxy-app
[HTTPProxyApplication]
Enables the HTTP Proxy application.
■ [0] Disable (default)
■ [1] Enable
Note: For the parameter to take effect,
a device reset is required.
- 1437 -