AudioCodes Mediant 800 - Page 1478

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
'HTTP Proxy Debug Level'
configure network > http-proxy >
http-proxy-debug-level
[HTTPProxySyslogDebugLevel]
Enables debugging of HTTP services
and the filtering of the messages sent
to the Syslog server by severity
(debug) level.
■ [0] No Debug = (Default) Disable.
■ [1] Info = Enables debug and
sends basic information in Syslog.
■ [2] Notice = Enables debug and
sends normal but significant
information in Syslog.
■ [3] Warning = Enables debug and
sends warning conditions in
Syslog.
■ [4] Error = Enables debug and
sends error conditions in Syslog.
■ [5] Critical = Enables debug and
sends critical conditions in Syslog.
■ [6] Alert = Enables debug and
sends conditions in Syslog that
require immediate action.
■ [7] Emergency = Enables debug
and sends conditions indicating
unstable system in Syslog.
Note: The NGINX Directive for this
parameter is "error_log, access_log".
'Primary DNS Server IP'
dns-primary-server
[HTTPPrimaryDNS]
Defines the primary DNS server (in
dotted-decimal notation), which is used
for translating domain names into IP
addresses for the HTTP service.
By default, no IP address is defined.
'Secondary DNS Server IP'
dns-secondary-server
[HTTPSecondaryDNS]
Defines the secondary DNS server (in
dotted-decimal notation), which is used
for translating domain names into IP
addresses for the HTTP service.
By default, no IP address is defined.
'HTTP Proxy Global Address'
configure network > http-proxy >
http-proxy-global-address
[HttpProxyGlobalAddress]
Defines the device's public IP address
for the HTTP Proxy service, when the
device is located behind NAT.
The valid value is an IP address in
dotted-decimal notation. The default is
0.0.0.0.
For more information, see Configuring
a Public IP Address for NGINX NAT
Traversal on page292.
- 1438 -