AudioCodes Mediant 800 - Configuring Gateway User Information Table from a Loadable File

CHAPTER20 SIP Definitions
Mediant 800 Gateway & E-SBC | User's Manual
password (0aGzoKfh5uI=)
status (not-resgistered)
■ To view a specific entry (example):
(sip-def-proxy-and-reg)# user-info gw-user-info <index, e.g., 0>
(gw-user-info-0)# display
pbx-ext (405)
global-phone-num (405)
display-name (Ext405)
username (user405)
password (0aGzoKfh5uI=)
status (not-resgistered)
■ To search a user by pbx-ext:
(sip-def-proxy-and-reg)# user-info find <pbx-ext e.g., 405>
405: Found at index 0 in GW user info table, not registered
To configure the User Information table, make sure that you have enabled the feature
(see Enabling the User Info Table).
Configuring Gateway User Information Table from a Loadable File
You can configure users in a file and then load (import) it to the User Information table. The users
must be configured in comma-separated value (CSV) file format. You can create the file using any
standard text-based editor such as Notepad, or alternatively a CSV-based program such as
Microsoft Excel. The file can have any filename extension (e.g., .csv or .txt).
When you import a file, all previously configured entries in the table are deleted and
replaced with the users from the imported file.
When adding users to the file, use the following syntax:
■ For text-based editors:
PBXExtension,GlobalPhoneNumber,DisplayName,Username,Password
For example:
PBXExtension,GlobalPhoneNumber,DisplayName,Username,Password
4040,7362400,John,johnd,2798
4041,7362401,Sue,suep,1234
■ For CSV-based programs:
PBXExtension,GlobalPhoneNumber,DisplayName,Username,Password
For example:
- 497 -