CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
Note: If set to Control, only one Control interface must be
configured in the IP Interfaces table; otherwise, RADIUS
communication will fail.
'RADIUS VSA Vendor ID'
configure system >
radius settings >
vsa-vendor-id
[RadiusVSAVendorID]
Defines the vendor ID that the device accepts when parsing a
RADIUS response packet.
The valid range is 0 to 0xFFFFFFFF. The default is 5003.
[MaxRADIUSSessions] Defines the number of concurrent calls that can communicate
with the RADIUS server (optional).
The valid range is 0 to 240. The default is 240.
'RADIUS Packets
Retransmission'
[RADIUSRetransmission]
Defines the number of RADIUS retransmission retries when
no response is received from the RADIUS server. See also
the RadiusTo parameter.
The valid range is 1 to 10. The default is 1.
'RADIUS Response Time
Out'
[RadiusTO]
Defines the time interval (in seconds) that the device waits for
a response before it performs a RADIUS retransmission. See
also the RADIUSRetransmission parameter.
The valid range is 1 to 30. The default is 2.
RADIUS Accounting Parameters
'RADIUS Accounting Type'
configure voip > sip-
definition settings >
radius-accounting
[RADIUSAccountingType]
Defines at what stage of the call RADIUS accounting
messages are sent to the RADIUS accounting server.
■ [0] At Call Release = (Default) Sent at call release only.
■ [1] At Connect & Release = Sent at call connect and
release.
■ [2] At Setup & Release = Sent at call setup and release.
'AAA Indications'
configure system >
cdr > aaa-indications
[AAAIndications]
Enables the Authentication, Authorization and Accounting
(AAA) indications.
■ [0] None = (Default) No indications.
■ [3] Accounting Only = Only accounting indications are
used.
RADIUS User Authentication Parameters
'Use RADIUS for Web/Telnet
Login'
configure system >
radius settings >
enable-mgmt-login
[WebRADIUSLogin]
Enables RADIUS queries for Web and Telnet login
authentication. When enabled, logging into the device's Web
and Telnet embedded servers is done through a RADIUS
server. The device communicates with a user-defined
RADIUS server and verifies the given username and
password against a remote database in a secure manner.
■ [0] Disable (default)
■ [1] Enable
Note:
- 1433 -
To Next Page
Loading...
