CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ [1] = Enable. Delimiters such as '*',
'#', and 'ST' are added to the received
address or received ANI digits string.
configure voip > interface e1-t1 >
cas-delimiters-types
[CASDelimitersPaddingUsage]
Defines the digits string delimiter padding
usage per trunk.
■ [0] = (Default) Default address string
padding: '*XXX#' (where XXX is the
digit string that begins with '*' and
ends with '#', when using padding).
■ [1] = Special use of asterisks
delimiters: '*XXX*YYY*' (where XXX
is the address, YYY is the source
phone number, and '*' is the only
delimiter padding).
Note: For the parameter to take effect, a
device reset is required.
[CASFileName_x] Defines the CAS file name (e.g., 'E_M_
WinkTable.dat') that defines the CAS
protocol, where x denotes the CAS file ID
(0-7). It is possible to define up to eight
different CAS files by repeating the
parameter. Each CAS file can be
associated with one or more of the
device's trunks, using the parameter
CASTableIndex_x.
Note: For the parameter to take effect, a
device reset is required.
[CASTablesNum] Defines the number of loaded CAS
protocol configurations files.
The valid range is 1 to 8.
Note: For the parameter to take effect, a
device reset is required.
CAS State Machines Parameters
Note: To configure the CAS State Machine table using the Web interface, see Configuring CAS
State Machines. The CAS state machine can be configured only through the Web-based
management tool.
'Generate Digit On Time'
[CASStateMachineGenerateDigitOnTime]
Generates digit on-time (in msec).
The value must be a positive value. The
default is -1.
'Generate Inter Digit Time'
[CASStateMachineGenerateInterDigitTime]
Generates digit off-time (in msec).
The value must be a positive value. The
default is -1.
'DTMF Max Detection Time'
[CASStateMachineDTMFMaxOnDetectionTime]
Detects digit maximum on time (according
to DSP detection information event) in
msec units.
- 1341 -