AudioCodes Mediant 800 - Page 1051

CHAPTER57 Viewing Performance Monitoring
Mediant 800 Gateway & E-SBC | User's Manual
● The PacketSmart feature is a license-based feature and is available only if it is
included in the License Key installed on the device. For ordering the feature, please
contact the sales representative of your purchased device.
● Before configuring the PacketSmart agent, configure the following:
✔ Correct data and time of the device. It is recommended to use an NTP server
to obtain the date and time (see Configuring Automatic Date and Time using
SNTP).
✔ IP network interface for communicating with the PacketSmart server.
Typically, the OAMP interface is used. To configure IP network interfaces, see
Configuring IP Network Interfaces.
✔ IP network interface for the VoIP traffic that you want monitored by
PacketSmart.
● For detailed information on setting up the PacketSmart solution, refer to the
document, Mediant Gateways and SBCs with BroadCloud PacketSmart
Configuration Note.
The following procedure describes how to configure PacketSmart through the Web interface. You
can also configure it through ini file or CLI (configure system > packetsmart).
➢ To configure the PacketSmart agent:
1. Open the Network Settings page (Setup menu > IP Network tab > Advanced folder >
Network Settings).
2. From the 'PacketSmart Agent Mode' drop-down list, select Enable to enable the feature.
3. Configure the remaining parameters, as required. For parameter descriptions, see
PacketSmart Parameters.
The following read-only fields are displayed:
● 'ID': Displays the name and serial number of the PacketSmart agent (i.e., the device) on
the PacketSmart server.
● 'Platform': Displays the name of the device.
4. Click Submit, and then reset the device with a save-to-flash for your settings to take effect.
- 1011 -