CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
'New RTP Stream Packets'
[NewRtpStreamPackets]
Defines the minimum number of continuous RTP packets
received by the device's channel to allow latching onto the
new incoming stream.
The valid range is 0 to 20. The default is 3. If set to 0, the
device is left exposed to attacks against multiple packet
streams.
'New RTCP Stream Packets'
[NewRtcpStreamPackets]
Defines the minimum number of continuous RTCP
packets received by the device's channel to allow latching
onto the new incoming stream.
The valid range is 0 to 20. The default is 3. If set to 0, the
device is left exposed to attacks against multiple packet
streams.
'New SRTP Stream Packets'
[NewSRTPStreamPackets]
Defines the minimum number of continuous SRTP
packets received by the device's channel to allow latching
onto the new incoming stream.
The valid range is 0 to 20. The default is 3. If set to 0, the
device is left exposed to attacks against multiple packet
streams.
'New SRTCP Stream Packets'
[NewSRTCPStreamPackets]
Defines the minimum number of continuous SRTCP
packets received by the device's channel to allow latching
onto the new incoming stream.
The valid range is 0 to 20. The default is 3. If set to 0, the
device is left exposed to attacks against multiple packet
streams.
'Timeout To Relatch RTP'
[TimeoutToRelatchRTPMsec]
Defines a period (msec) during which if no packets are
received from the current RTP session, the channel can
re-latch onto another stream.
The valid range is any value from 0. The default is 200.
'Timeout To Relatch SRTP'
[TimeoutToRelatchSRTPMsec]
Defines a period (msec) during which if no packets are
received from the current SRTP session, the channel can
re-latch onto another stream.
The valid range is any value from 0. The default is 200.
'Timeout To Relatch Silence'
[TimeoutToRelatchSilenceMsec]
Defines a period (msec) during which if no packets are
received from the current RTP/SRTP session and the
channel is in silence mode, the channel can re-latch onto
another stream.
The valid range is any value from 0. The default is 200.
'Timeout To Relatch RTCP'
[TimeoutToRelatchRTCPMsec]
Defines a period (msec) during which if no packets are
received from the current RTCP session, the channel can
re-latch onto another RTCP stream.
The valid range is any value from 0. The default is 10,000.
'Fax Relay Rx/Tx Timeout'
[FaxRelayTimeoutSec]
Defines a period (sec) during which if no T.38 packets are
received or sent from the current T.38 fax relay session,
the channel can re-latch onto another stream.
- 1202 -
To Next Page
Loading...
