AudioCodes Mediant 800 - Page 1251

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
[SSHServerEnable] ■ [1] Enable (default)
'Server Port'
configure system > cli-
settings > ssh-port
[SSHServerPort]
Defines the port number for the embedded SSH server.
Range is any valid port number. The default port is 22.
'Redundant Proxy Port'
configure system > cli-
settings > ssh-red-
device-port
[SSHRedundantProxyPort]
Defines the proxy SSH port number on the active device for
accessing the redundant device's embedded SSH server
from the active device for downloading files from the
redundant device.
The valid value is any valid port number. The default port is
0 (i.e., disabled).
Note:
■ The parameter is applicable only when the device is in
HA mode.
■ The port number must be different to the regular SSH
port number, which is configured by the SSHServerPort
parameter.
'Public Key'
configure system > cli-
settings > ssh-require-
public-key
[SSHRequirePublicKey]
Enables RSA public keys for SSH.
■ [0] Disable = (Default) RSA public keys are optional if
a public key is configured.
■ [1] Enable = RSA public keys are mandatory.
Note:
■ Public keys are configured per management user in the
Local Users table (see Configuring Management User
Accounts on page42).
■ To define the key size, use the TLSPkeySize
parameter.
'Max Payload Size'
ssh-max-payload-size
[SSHMaxPayloadSize]
Defines the maximum uncompressed payload size (in
bytes) for SSH packets.
The valid value is 550 to 32768. The default is 32768.
'Max Binary Packet Size'
configure system > cli-
settings > ssh-max-
binary-packet-size
[SSHMaxBinaryPacketSize]
Defines the maximum packet size (in bytes) for SSH
packets.
The valid value is 582 to 35000. The default is 35000.
'Maximum SSH Sessions'
configure system > cli-
settings > ssh-max-
sessions
[SSHMaxSessions]
Defines the maximum number of simultaneous SSH
sessions.
The valid range is 1 to 5. The default 5.
- 1211 -