AudioCodes Mediant 800 - Page 131

CHAPTER13 Network
Mediant 800 Gateway & E-SBC | User's Manual
2. Select a port that you want to configure, and then click Edit; the following dialog box appears:
3. Configure the port according to the parameters described in the table below.
4. Click Apply, and then reset the device with a burn-to-flash for your settings to take effect.
Table 13-2: Physical Ports Table Parameter Descriptions
Parameter Description
General
'Index' (Read-only) Displays the index number for the table row.
'Name'
port
[PhysicalPortsTable_
Port]
(Read-only) Displays the Ethernet port number. See the figure in the
beginning of this section for the mapping between the GUI port
number and the physical port on the chassis.
'Description'
port-
description
[PhysicalPortsTable_
PortDescription]
Defines a description of the port.
By default, the value is "User Port #<row index>".
Note: Each row must be configured with a unique name.
'Mode'
mode
[PhysicalPortsTable_
Mode]
(Read-only) Displays the mode of the port.
■ [0] Disable
■ [1] Enable (default)
'Speed and Duplex'
speed-duplex
[PhysicalPortsTable_
SpeedDuplex]
Defines the speed and duplex mode of the port.
■ [0] 10BaseT Half Duplex
■ [1] 10BaseT Full Duplex
■ [2] 100BaseT Half Duplex
■ [3] 100BaseT Full Duplex
■ [4] Auto Negotiation (default)
■ [6] 1000BaseT Half Duplex
■ [7] 1000BaseT Full Duplex
Ethernet Group
'Member of Ethernet
Group'
group-member
(Read-only) Displays the Ethernet Group to which the port belongs.
To assign the port to a different Ethernet Group, see Configuring
Ethernet Port Groups.
- 91 -