AudioCodes Mediant 800 - Page 135

CHAPTER13 Network
Mediant 800 Gateway & E-SBC | User's Manual
You cannot delete an Ethernet Device that is associated with an IP network interface
(in the IP Interfaces table). You can only delete it once you have disassociated it from
the IP network interface.
The following procedure describes how to configure Ethernet Devices through the Web interface.
You can also configure it through ini file [DeviceTable] or CLI ( configure network >
network-dev).
➢ To configure an Ethernet Device:
1. Open the Ethernet Devices table (Setup menu > IP Network tab > Core Entities folder >
Ethernet Devices).
2. Click New; the following dialog box appears:
3. Configure an Ethernet Device according to the parameters described in the table below.
4. Click Apply.
Table 13-4: Ethernet Devices Table Parameter Descriptions
Parameter Description
'Index'
[DeviceTable_
Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
'Name'
name
[DeviceTable_
DeviceName]
Defines a name for the Ethernet Device. The name is used to
associate the Ethernet Device with an IP network interface in the IP
Interfaces table ('Underlying Device' field - see Configuring IP Network
Interfaces) and/or with a static route in the Static Routes table
('Ethernet Output Device' field - see Configuring Static IP Routing).
'VLAN ID'
vlan-id
[DeviceTable_
VlanID]
Defines a VLAN ID for the Ethernet Device.
The valid value is 1 to 3999. The default is 1.
Note: Each Ethernet Device must be configured with a unique VLAN
ID.
- 95 -