EasyManua.ls Logo

AudioCodes Mediant 800 - Page 1368

AudioCodes Mediant 800
1482 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
[0] = (Default) Standard Mode - ETS calls have the
highest priority and preempt any MLPP call.
[1] = Treat as routine mode - ETS calls are handled
as routine calls.
Note: The parameter is applicable only to analog
interfaces.
resource-prio-req
[RPRequired]
Defines if the device adds the SIP 'resource-priority'
tag to the SIP Require header of INVITE messages for
Tel-to-IP calls.
[0] = Disable. The device excludes the SIP
'resource-priority' tag from the SIP Require header.
[1] = (Default) Enable. The device adds the SIP
'resource-priority' tag to the SIP Require header.
Note: The parameter is applicable only to MLPP
priority call handling (i.e., only when the
CallPriorityMode parameter is configured to [1]).
Multiple Differentiated Services Code Points (DSCP) per MLPP Call Priority Level
(Precedence) Parameters
The MLPP service allows placement of priority calls, where properly validated users can
preempt (terminate) lower-priority phone calls with higher-priority calls. For each MLPP call
priority level, the DSCP can be set to a value from 0 to 63. The Resource Priority value in the
Resource-Priority SIP header can be one of the following:
MLPP Precedence Level Precedence Level in Resource-Priority SIP Header
0 (lowest) routine
2 priority
4 immediate
6 flash
8 flash-override
9 (highest) flash-override-override
'RTP DSCP for MLPP Routine'
dscp-4-mlpp-rtn
[MLPPRoutineRTPDSCP]
Defines the RTP DSCP for MLPP Routine precedence
call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the
global parameter PremiumServiceClassMediaDiffServ
or as defined in IP Profiles per call.
'RTP DSCP for MLPP Priority'
dscp-4-mlpp-prio
[MLPPPriorityRTPDSCP]
Defines the RTP DSCP for MLPP Priority precedence
call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the
global parameter PremiumServiceClassMediaDiffServ
or as defined in IP Profiles per call.
- 1328 -

Table of Contents

Other manuals for AudioCodes Mediant 800

Related product manuals