AudioCodes Mediant 800 - Page 1372

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfu-code
[SuppServCodeCFU]
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g.,
‘*72’).
'Call Forward Unconditional
Deactivation'
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfu-
deactivation-code
[SuppServCodeCFUDeact]
Defines the prefix code for deactivating Call Forward
Unconditional Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g.,
‘*72’).
'Call Forward on Busy'
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfb-code
[SuppServCodeCFB]
Defines the prefix code for activating Call Forward on Busy
sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g.,
‘*72’).
'Call Forward on Busy
Deactivation'
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfb-
deactivation-code
[SuppServCodeCFBDeact]
Defines the prefix code for deactivating Call Forward on Busy
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g.,
‘*72’).
'Call Forward on No Reply'
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfnr-code
[SuppServCodeCFNR]
Defines the prefix code for activating Call Forward on No
Reply sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g.,
‘*72’).
'Call Forward on No Reply
Deactivation'
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfnr-
deactivation-code
[SuppServCodeCFNRDeact]
Defines the prefix code for deactivating Call Forward on No
Reply Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g.,
‘*72’).
- 1332 -