AudioCodes Mediant 800 - Page 1376

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ [0] = Lock the trunk; stops trunk traffic to configure
the trunk protocol type.
■ [1] = Shutting down (read only).
■ [2] = (Default) Unlock the trunk; enables trunk traffic.
Note:
■ For the parameter to take effect, a device reset is
required.
■ When the device is locked from the Web interface,
the parameter changes to 0.
■ To define the administrative state per trunk, use the
TrunkAdministrativeState parameter.
[TrunkAdministrativeState_x] Defines the administrative state per trunk, where x
denotes the trunk number.
■ [0] = Lock the trunk; stops trunk traffic to configure
the trunk protocol type.
■ [1] = shutting down (read only).
■ [2] = (Default) Unlock the trunk; enables trunk traffic.
[TDMHairPinning] Defines static TDM hair-pinning (cross-connection)
performed at initialization. The connection is between
trunks with an option to exclude a single B-channel in
each trunk. Format example: T0-T1/B3,T2-T3,T4-T5/B2.
Note:
■ For the parameter to take effect, a device reset is
required.
■ The parameter is applicable only to PRI.
[TDMHairPinningAlarmIndication] Enables two trunks that are connected through TDM
hairpinning to signal the Far-End about the presence of
PSTN alarms. When the trunk with TDM hairpinning
receives a PSTN alarm, its' connected trunk sends an
AIS alarm to its' Far-End.
■ [0] = (Default) Disable
■ [1] = Enable
Note:
■ For the parameter to take effect, a device reset is
required.
■ The parameter is applicable only to PRI.
'Enable TDM Tunneling'
tdm-tunneling
[EnableTDMoverIP]
Enables TDM tunneling for all calls.
■ [0] Disable (default)
■ [1] Enable = Enables TDM tunneling. For more
information, see TDM Tunneling.
■ [2] Private Wire = Enables TDM tunneling for private
wire services. For more information, see Configuring
Private Wire Interworking.
Note:
- 1336 -