AudioCodes Mediant 800 - Page 1403

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
You can also configure the feature per specific calls,
using Tel Profiles (TelProfile_TimeForReorderTone).
For a detailed description of the parameter and for
configuring the feature in the Tel Profiles table, see
Configuring Tel Profiles.
Note: If the feature is configured for a specific Tel
Profile, the settings of the global parameter is ignored
for calls associated with the Tel Profile.
'Time Before Reorder Tone'
time-b4-reordr-tn
[TimeBeforeReorderTone]
Defines the delay interval (in seconds) from when the
device receives a SIP BYE message (i.e., remote party
terminates call) until the device starts playing a reorder
tone to the FXS phone.
The valid range is 0 to 60. The default is 0.
Note: The parameter is applicable only to FXS
interfaces.
'Cut Through Reorder Tone
Duration'
cut-thru-reord-dur
[CutThroughTimeForReOrderTone]
Defines the duration (in seconds) of the reorder tone
played to the Tel side after the IP call party releases the
call, for the Cut-Through feature. After the tone stops
playing, an incoming call is immediately answered if:
■ Analog interfaces: The FXS is off-hooked.
■ Digital interfaces: The PSTN is connected.
The valid values are 0 to 30. The default is 0 (i.e., no
reorder tone is played).
Note: To enable the Cut-Through feature:
■ CAS channels: DigitalCutThrough parameter
■ FXS channels: CutThrough parameter
'Enable Comfort Tone'
comfort-tone
[EnableComfortTone]
Determines whether the device plays a comfort tone
(Tone Type #18) to the FXS /FXO endpoint after a SIP
INVITE is sent and before a SIP 18x response is
received.
■ [0] Disable (default)
■ [1] Enable
Note: The parameter is applicable to FXS and FXO
interfaces.
[WarningToneDuration] Defines the duration (in seconds) for which the offhook
warning tone is played to the user.
The valid range is -1 to 2,147,483,647. The default is
600.
Note:
■ A negative value indicates that the tone is played
infinitely.
■ The parameter is applicable only to analog
interfaces.
'Play Busy Tone to Tel' Enables the device to play a busy or reorder tone to the
PSTN after a Tel-to-IP call is released.
- 1363 -