AudioCodes Mediant 800 - Page 1429

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ [1] Copy after phone number
manipulation = Copies the called
number after manipulation. The device
first performs Tel-to-IP destination
phone number manipulation (i.e., on the
SIP To header), and only then copies the
manipulated called number to the SIP
Diversion header for the Tel-to-IP call.
Therefore, with this option, the called
and redirect numbers are identical.
■ [2] Copy before phone number
manipulation = Copies the called
number before manipulation. The device
first copies the original called number to
the SIP Diversion header, and then
performs Tel-to-IP destination phone
number manipulation. Therefore, this
allows you to have different numbers for
the called (i.e., SIP To header) and
redirect (i.e., SIP Diversion header)
numbers.
Note:
■ Digital interfaces: If the incoming ISDN-
to-IP call includes a Redirect Number,
this number is overridden by the new
called number if the parameter is set to
[1] or [2].
■ Digital interfaces: You can also use this
feature for IP-to-Tel calls, by configuring
the parameter per IP Profile (IpProfile_
CopyDest2RedirectNum). For more
information, see Configuring IP Profiles.
configure voip > sip-definition
settings > rep-calling-w-redir
[ReplaceCallingWithRedirectNumber]
Enables the replacement of the calling
number with the redirect number for ISDN-
to-IP calls.
■ [0] = Disable (default)
■ [1] = The calling name is removed and
left blank. The outgoing INVITE
message excludes the redirect number
that was used to replace the calling
number. The replacement is done only if
a redirect number is present in the
incoming Tel call.
■ [2] = Manipulation is done on the new
calling party number (after manipulation
of the original calling party number, using
the Tel2IPSourceNum-
berMappingDialPlanIndex parameter),
but before the regular calling or redirect
number manipulation:
- 1389 -