CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ If a call is already established and there is RTP, if
at any stage during the call RTP packets are not
detected for a user-defined interval (configured by
BrokenConnectionEventTimeout), the device
disconnects the call (or routes it to an alternative
destination, configured by the IpProfile_
DisconnectOnBrokenConnection).
■ For the SBC application, the parameter is not
applicable to direct media calls (see Direct Media
on page751).
'Trunk Alarm Call Disconnect
Timeout'
trk-alrm-call-disc-to
[TrunkAlarmCallDisconnectTimeout]
Defines the duration (in seconds) to wait after a digital
trunk "Red" alarm (LOS / LOF) is raised, before the
device disconnects the SIP call. If this timeout
expires and the alarm is still raised, the device sends
a SIP BYE message to terminate the call. If the alarm
is cleared before this timeout expires, the call is not
terminated, but continues as normal.
The range is 1 to 3600. The default is 0 (20 for BRI, 20
for E1 and 40 for T1).
Note: The parameter is applicable only to the
Gateway application.
'Disconnect Call on Busy Tone
Detection (ISDN)'
disc-on-bsy-tone-i
[ISDNDisconnectOnBusyTone]
Determines whether a call is disconnected upon
detection of a busy tone (for ISDN).
■ [0] Disable = (Default) Do not disconnect call
upon detection of busy tone.
■ [1] Enable = Disconnect call upon detection of
busy tone.
Note:
■ The parameter is applicable only to ISDN
protocols.
■ IP-to-ISDN calls are disconnected on detection of
SIT tones only in call alert state. If the call is in
connected state, the SIT does not disconnect the
calls. Detection of busy or reorder tones
disconnects the IP-to-ISDN calls also in call
connected state.
■ For IP-to-CAS calls, detection of busy, reorder, or
SIT tones disconnect the calls in any call state.
'Disconnect Call on Busy Tone
Detection (CAS)'
configure voip > gateway
analog fxo-setting > disc-
on-bsy-tone-c
[DisconnectOnBusyTone]
Global parameter enabling call disconnection upon
detection of a busy tone.
You can also configure the feature per specific calls,
using Tel Profiles (TelProfile_
DisconnectOnBusyTone). For a detailed description
of the parameter and for configuring the feature in the
Tel Profiles table, see Configuring Tel Profiles.
Note:
- 1398 -
To Next Page
Loading...
