CHAPTER14 Security
Mediant 800 Gateway & E-SBC | User's Manual
3. Configure the TLS Context according to the parameters described in the table below.
4. Click Apply, and then reset the device with a save-to-flash for your settings to take effect.
Table 14-1: TLS Contexts Parameter Descriptions
Parameter Description
General
'Index'
tls
[TLSContexts_Index]
Defines an index number for the new table row.
Note:
■ Each row must be configured with a unique index.
■ Index 0 ("default") is the default TLS Context.
'Name'
name
[TLSContexts_Name]
Defines a descriptive name, which is used when associating
the row in other tables.
The valid value is a string of up to 31 characters.
Note:
■ The parameter value cannot contain a forward slash (/).
■ The default TLS Context (Index 0) is named "default".
'TLS Version'
tls-version
[TLSContexts_TLSVersion]
Defines the supported SSL/TLS protocol version. Clients
attempting to communicate with the device using a different
TLS version are rejected.
■ [0] Any - Including SSLv3 = (Default) SSL 3.0 and all
TLS versions are supported.
■ [1] TLSv1.0 = Only TLS 1.0.
■ [2] TLSv1.1 = Only TLS 1.1.
■ [3] TLSv1.0 and TLSv1.1 = Only TLS 1.0 and TLS 1.1.
■ [4] TLSv1.2 = Only TLS 1.2.
■ [5] TLSv1.0 and TLSv1.2 = Only TLS 1.0 and TLS 1.2.
■ [6] TLSv1.1 and TLSv1.2 = Only TLS 1.1 and TLS 1.2.
■ [7] TLSv1.0 TLSv1.1 and TLSv1.2 = Only TLS 1.0, TLS
1.1 and TLS 1.2 (excludes SSL 3.0).
'DTLS Version'
[TLSContexts_DTLSVersion]
Defines the Datagram Transport Layer Security (DTLS)
version, which is used to negotiate keys for WebRTC calls.
■ [0] Any (default)
- 128 -
To Next Page
Loading...
Need help?
General
