AudioCodes Mediant 800 - Page 219

CHAPTER15 Media
Mediant 800 Gateway & E-SBC | User's Manual
Content-Type: Application/X-Detect
Type = [event type]
Subtype = [subtype of each event type]
The table below lists the event types and subtypes that can be detected by the device. The text
shown in the table are the strings used in the X-Detect header. The table also provides a summary
of the required configuration.
For SBC calls, event detection is enabled using the IPProfile_SBCHandleXDetect parameter in the
IP Profiles table (see Configuring IP Profiles).
Table 15-1: Supported X-Detect Event Types
Event
Type
Subtype Description and Required Configuration
AMD ■ Voice (live voice)
■ Automata (answering
machine)
■ Silence (no voice)
■ Unknown
■ Beep (greeting
message of
answering machine)
Event detection using the AMD feature. For more
information, see Answering Machine Detection (AMD).
CPT ■ SIT-NC
■ SIT-IC
■ SIT-VC
■ SIT-RO
■ Busy
■ Reorder
■ Ringtone
■ Beep (greeting
message of
answering message)
Event detection of tones using the CPT file.
1. Create a CPT file with the required tone types of the
events that you want to detect.
2. Install the CPT file on the device.
3. For SIT detection:
✔ Set the SITDetectorEnable parameter to 1.
✔ Set the UserDefinedToneDetectorEnable
parameter to 1.
Note:
■ For more information on SIT detection, see SIT Event
Detection.
■ To configure beep detection, see Detecting
Answering Machine Beep.
FAX CED ■ Set the IsFaxUsed parameter to any value other than
0.
- or -
■ Set the IsFaxUsed parameter to 0 and the
FaxTransportMode parameter to any value other than
0.
Note: Applicable only to the Gateway application.
modem Set the VxxModemTransportType parameter to 3.
Note: Applicable only to the Gateway application.
PTT ■ voice-start
■ voice-end
Set the EnableDSPIPMDetectors parameter to 1.
- 179 -