Content
Mediant 800 Gateway & E-SBC | User's Manual
Message Waiting Indication 682
Caller ID 683
Enabling Caller ID Generation and Detection on Tel Side 684
Debugging a Caller ID Detection on FXO 684
Caller ID on the IP Side 685
Three-Way Conferencing 686
Emergency E911 Phone Number Services 689
FXS Device Emulating PSAP using DID Loop-Start Lines 689
FXO Device Interworking SIP E911 Calls from Service Provider's IP Network to PSAP DID
Lines 691
Pre-empting Existing Calls for E911 IP-to-Tel Calls 695
Multilevel Precedence and Preemption 696
MLPP Preemption Events in SIP Reason Header 699
Precedence Ring Tone 700
Denial of Collect Calls 700
Configuring Multi-Line Extensions and Supplementary Services 700
Detecting Collect Calls 704
Advice of Charge Services for Euro ISDN 705
Configuring Charge Codes 707
Configuring Voice Mail 710
Converting Accented Characters from IP to Tel 712
29 Analog Gateway 714
Configuring Keypad Features 714
Configuring Metering Tones 715
Configuring FXO Settings 715
Configuring Authentication 716
Configuring Automatic Dialing 717
Configuring Caller Display Information 719
Configuring Call Forward 721
Configuring Caller ID Permissions 723
Configuring Call Waiting 724
Rejecting Anonymous Calls 726
Configuring FXS Distinctive Ringing and Call Waiting Tones per Source/Destination
Number 726
Analog Coefficient Types 728
FXO Operating Modes 729
FXO Operations for IP-to-Tel Calls 729
One-Stage Dialing 729
Two-Stage Dialing 730
DID Wink 731
FXO Operations for Tel-to-IP Calls 731
Automatic Dialing 731
Collecting Digits Mode 732
FXO Supplementary Services 732
Call Termination on FXO Devices 733
- xxx -
To Next Page
Loading...
