AudioCodes Mediant 800 - Page 329

CHAPTER16 Services
Mediant 800 Gateway & E-SBC | User's Manual
➢ To configure an OVOC Service:
1. Open the OVOC Services table (Setup menu > IP Network tab > HTTP Proxy folder > OVOC
Services).
2. Click New; the following dialog box appears:
3. Configure an OVOC Service according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
Table 16-28:OVOC Services Table Parameter Descriptions
Parameter Description
General
'Index'
[OVOCService_Index]
Defines an index number for the new table row.
Note:
■ Each row must be configured with a unique index.
■ The parameter is mandatory.
'Name'
service-name
[OVOCService_
ServiceName]
Defines a descriptive name, which is used when associating the
row in other tables.
The valid value is a string of up to 40 characters. By default, no
value is defined.
Note:
■ Each row must be configured with a unique name.
■ The parameter is mandatory.
Device
'Device Login Interface'
device-login-
interface
[OVOCService_
DeviceLoginInterface]
Assigns an IP network interface (local, listening HTTP
interface:port) for communication with the client. To configure IP
Interfaces, see Configuring IP Network Interfaces on page97.
By default, no value is defined.
Note:
■ The parameter is mandatory.
■ The NGINX directive for this parameter is "proxy_bind".
'Device Login Port'
device-login-port
[OVOCService_
DeviceLoginPort]
Defines the login port of the requesting client.
Note: The NGINX directive for this parameter is "proxy_bind".
- 289 -