AudioCodes Mediant 800 - Page 391

CHAPTER18 Core Entities
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
'UDP Port'
udp-port
[SIPInterface_UDPPort]
Defines the device's listening and source port for SIP
signaling traffic over UDP.
The valid range is 1 to 65534. The default is 5060.
Note:
■ The port must be different from ports configured
for RTP traffic (i.e., ports configured for Media
Realms and Media Realm Extensions) using the
same IP network interface. For example, if the
RTP port range is 6000 to 6999, the SIP port can
either be less than 6000 or greater than 6999.
■ Each SIP Interface must have a unique signaling
port (i.e., no two SIP Interfaces can share the
same port - no port overlapping).
'TCP Port'
tcp-port
[SIPInterface_TCPPort]
Defines the device's listening port for SIP signaling
traffic over TCP.
The valid range is 1 to 65534. The default is 5060.
Note:
■ The port must be different from ports configured
for RTP traffic (i.e., ports configured for Media
Realms and Media Realm Extensions) using the
same IP network interface. For example, if the
RTP port range is 6000 to 6999, the SIP port can
either be less than 6000 or greater than 6999.
■ Each SIP Interface must have a unique signaling
port (i.e., no two SIP Interfaces can share the
same port - no port overlapping).
'TLS Port'
tls-port
[SIPInterface_TLSPort]
Defines the device's listening port for SIP signaling
traffic over TLS.
The valid range is 1 to 65534. The default is 5061.
Note:
■ The port must be different from ports configured
for RTP traffic (i.e., ports configured for Media
Realms and Media Realm Extensions) using the
same IP network interface. For example, if the
RTP port range is 6000 to 6999, the SIP port can
either be less than 6000 or greater than 6999.
■ Each SIP Interface must have a unique signaling
port (i.e., no two SIP Interfaces can share the
same port - no port overlapping).
'Additional UDP Ports'
additional-udp-ports
[SIPInterface_AdditionalUDPPorts]
Defines a port range for the device's local, listening
and source ports for SIP signaling traffic over UDP.
The parameter can be used for the following features:
- 351 -