AudioCodes Mediant 800 - Page 510

CHAPTER19 Coders and Profiles
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ [1] Cut-Through = (Enabled with tones) Calls can be
received in off-hook state. When the IP side ends the
call, the device can play a reorder tone to the Tel side
for a user-defined duration (configured by the
CutThroughTimeForReorderTone parameter). Once the
tone stops playing, the FXS phone is ready to
automatically answer another incoming IP call in off-
hook state. A waiting call is automatically answered by
the device when the current call is terminated (and if the
EnableCallWaiting parameter is configured to 1).
■ [2] Cut-Through and Paging = (Enabled and no
tones) Calls can be received in off-hook state, but no
tones are played (before or after the call) in off-hook
state. The option is useful for paging calls, which
provides a one-way voice path from the paging phone to
the paged phones (FXS phones).
■ [3] Cut-Through and Streaming = Enabled and
allows playing music-on-hold (MoH) that is received
from an external media (audio) player. For more
information, see Configuring MoH from External Audio
Source on page669.
Note:
■ The parameter is applicable only to FXS interfaces.
■ The corresponding global parameter is CutThrough. this
global parameter currently does not support the
CutThrough+Streaming option.
Voice
'DTMF Volume'
dtmf-volume
[TelProfile_DtmfVolume]
Defines the DTMF gain control value (in decibels) to the Tel
side.
The valid range is -31 to 0 dB. The default is -11 dB.
Note: The corresponding global parameter is
DTMFVolume.
'Input Gain'
input-gain
[TelProfile_InputGain]
Defines the pulse-code modulation (PCM) input (received)
gain control level (in decibels), which is the level of the
received signal for Tel-to-IP calls.
The valid range is -32 to 31 dB. The default is 0 dB.
Note: The corresponding global parameter is InputGain.
'Voice Volume'
voice-volume
[TelProfile_VoiceVolume]
Defines the voice gain control (in decibels), which is the
level of the transmitted signal for IP-to-Tel calls.
The valid range is -32 to 31 dB. The default is 0 dB.
Note: The corresponding global parameter is VoiceVolume
'Enable AGC'
enable-agc
[TelProfile_EnableAGC]
Enables the Automatic Gain Control (AGC) feature. The
AGC feature automatically adjusts the level of the received
signal to maintain a steady (configurable) volume level.
■ [0] Disable (default)
■ [1] Enable
- 470 -