EasyManua.ls Logo

AudioCodes Mediant 800 - Page 514

AudioCodes Mediant 800
1482 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER19 Coders and Profiles
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
[TelProfile_IPDiffServ] The valid range is 0 to 63. The default is 46.
Note:
For more information on DiffServ, see Configuring
Class-of-Service QoS.
The corresponding global parameter is Premi-
umServiceClassMediaDiffServ.
'Signaling DiffServ'
signaling-diffserv
[TelProfile_SigIPDiffServ]
Defines the DiffServ value for Premium Control CoS
content (Call Control applications).
The valid range is 0 to 63. The default is 40.
Note:
For more information on DiffServ, see Configuring
Class-of-Service QoS.
The corresponding global parameter is Premi-
umServiceClassControlDiffServ.
'Enable Early Media'
early-media
[TelProfile_EnableEarlyMedia]
Enables the Early Media feature, which sends media (e.g.,
ringing) before the call is established.
[0] Disable (default)
[1] Enable
Digital: The device sends a SIP 18x response with
SDP, allowing the media stream to be established
before the call is answered.
Analog: The device sends a SIP 183 Session
Progress response with SDP instead of a 180
Ringing, allowing the media stream to be
established before the call is answered.
Note:
Digital: The inclusion of the SDP in the 18x response
depends on the ISDN Progress Indicator (PI). The SDP
is sent only if PI is set to 1 or 8 in the received
Proceeding, Alerting, or Progress messages. See also
the ProgressIndicator2IP parameter, which if set to 1 or
8, the device behaves as if it received the ISDN
messages with the PI.
CAS: See the ProgressIndicator2IP parameter.
ISDN: Sending a 183 response depends on the
ISDN PI. It is sent only if PI is set to 1 or 8 in the
received Proceeding or Alerting messages.
Sending 183 response also depends on the
ReleaseIP2ISDNCallOnProgressWithCause
parameter, which must be set to any value other
than 2.
Digital: See also the IgnoreAlertAfterEarlyMedia
parameter. The parameter allows, for example, to
interwork Alert with PI to SIP 183 with SDP instead of
180 with SDP.
- 474 -

Table of Contents

Other manuals for AudioCodes Mediant 800

Related product manuals