To Next Page

To Previous Page

CHAPTER37 Advanced SBC Features

Mediant 800 Gateway & E-SBC | User's Manual

2. Configure the keep-alive interval with the WebSocket client:

a. On the Transport Settings page (Setup menu > Signaling & Media tab > SIP

Definitions folder > Transport Settings), and then in the 'WebSocket Keep-Alive Period'

field (WebSocketProtocolKeepAlivePeriod), enter the keep-alive interval:

b. Click Apply.

3. Configure a SIP Interface for the WebRTC clients that identifies WebSocket traffic:

a. Open the SIP Interfaces table (see Configuring SIP Interfaces).

b. Do the following:

◆ From the 'Encapsulating Protocol' drop-down list (SIPInterface_

EncapsulatingProtocol), select WebSocket.

◆ In the 'TLS Port' field, configure the TLS port.

◆ From the 'TLS Context Name' drop-down list, assign the TLS Context that you

configured in Step 1 (e.g., "WebRTC").

c. Click Apply.

4. Configure an IP Profile for the WebRTC clients:

a. Open the IP Profiles table (see Configuring IP Profiles).

b. Do the following:

◆ From the 'ICE Mode' drop-down list (IPProfile_SBCIceMode), select Lite to enable

ICE.

◆ From the 'RTCP Mux' drop-down list (IPProfile_SBCRTCPMux), select Supported

to enable RTCP multiplexing.

◆ From the 'RTCP Feedback' drop-down list (IPProfile_SBCRTCPFeedback), select

Feedback On to enable RTCP feedback.

- 858 -

AudioCodes Mediant 800 User Manual

Other manuals for AudioCodes Mediant 800