User's Manual 10. Making VoIP Calls with your Analog Telephones
Version 4.4.3 111 MP-20x Multimedia Home Gateway
10 Making VoIP Calls with your Analog
Telephones
Analog telephone users that are connected to the device can place calls, put calls on hold,
transfer calls, and establish three-way conferences. The procedures below decribe how to
perform these operations.
10.1 Making a Call
The procedure below describes how to make a call.
To make a call:
1. Pick up the phone.
2. Make sure that you can hear a dial tone
3. Dial the remote party's number or the user-defined speed dial number (if configured in
Section 9.9 on page 107).
Note: When calling another internal extension, dial “**0” for FXS1, “**1” for FXS2, “**2”.
10.2 Answering a Waiting Call
The procedure below describes how to answer a waiting call. This depends on how you
configured the flash-hook functionality, using the ‘Flash keys sequence style’ parameter in
Section 9.2 on page 82. To enable call waiting, see Section 9.5 on page 96.
To answer a waiting call when 'Flash only' is set:
1. When you hear a call waiting tone (during a call), press the flash key button on your
phone; the active call is put on hold and switches to the waiting call.
2. To return to the original call, press the flash button again. You can toggle from one
party to another by pressing the flash button.
To answer a waiting call when 'Flash + digits sequence' is set:
1. When you hear the call waiting tone (during a call), press the flash key button on your
phone and then press the '1' key; the original call is put on hold and switches to the
waiting call.
2. To return to the original call, press flash + 1 again. You can toggle from one party to
another by pressing flash + 1.
To Next Page
Loading...
Need help?
General
