EasyManua.ls Logo

AudioCodes MP-20 Series - 2 Cabling the MP-20 X Telephone Adapter; Figure 2-1: Cabling the Device (Example Using MP-204 B)

AudioCodes MP-20 Series
346 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User's Manual 2. Cabling the MP-20x Telephone Adapter
Version 4.4.3 19 MP-20x Multimedia Home Gateway
2 Cabling the MP-20x Telephone Adapter
The procedure below describes how to cable the MP-20x.
To cable the MP-20x:
1. Connect the MP-204’s Ethernet connector labeled WAN to your cable or DSL modem,
using the Ethernet cable.
2. Connect the MP-204’s Ethernet connector labeled LAN/PC to your PC, using the
second Ethernet cable.
3. Connect the MP-204’s telephone ports labeled PHONE to analog telephones/faxes,
using the RJ-11 telephone cables. (The number of telephone ports depends on your
MP-204 model.)
4. Connect MP-204 to a standard 110/220 VAC electrical wall outlet, using the AC/DC
power adapter; the POWER LED is lit (green) and when initialization completes (~ 1
minute), the STATUS LED changes from red to green.
5. The USB port can be used as a secondary WAN (with 3G/4G dongles) or to connect a
disk-on-key, external hard disk drive or printer.
Figure 2-1: Cabling the Device (Example using MP-204B)

Table of Contents

Other manuals for AudioCodes MP-20 Series

Related product manuals