User's Manual 20. Maintenance
Version 4.4.3 315 MP-20x Multimedia Home Gateway
20.5.1 Upgrading the Device from a Computer on the Network
The procedure below describes how to upgrade the device from a software image file
located on a local computer or network.
Note: You can only use files with an *.rmt extension when performing the firmware
upgrade procedure.
To upgrade the device software image using a locally available .rmt file:
1. On the 'Advanced' screen, click the Firmware Upgrade icon; the ‘MP202D
Firmware Upgrade' screen appears.
Figure 20-13: Firmware Upgrade Screen – New Versions
The following is an example of the relevant Telnet parameter:
rg_conf/rmt_upd/wan_upgrade_type=1
(Automatically check for New Versions)
To Next Page
Loading...
Need help?
General
